D&D - ClariSea SK-3000 Automatic Filter System

The ClariSea SK-3000 Automatic Filter System is a high-efficiency water filtration system that effectively removes suspended particles such as microalgae, detritus, food, organic waste, and gravel dust from the water column.

Suitable for use in marine aquariums, freshwater aquariums, fish-breeding systems, and propagation systems for corals.

Features:

High volume filtration capacity
Minimal installation footprint
Completely replaces the need for filter socks
Self-assembly for easy cleaning
Multiple installation options
Automatic advance of fleece when dirty.
Phosphate-free fleece material
Special low-odour fleece material
Integrated fail-safe overflow
Silencer plates for quiet operation
Water bypass system

Specifications:

Recommended flow rate: 3,000 l/h (800 US gph)
Particle size removal: down to 20 microns
Maximum submerged water depth: 20cm (8”)
Hang-on bracket height adjustment: up to 12cm (4”)
Maximum sump glass thickness for hang on bracket: 13mm (1/2")
Recommended aquarium size at 5 x tank turn over (3000l/hr) = 600lt
Recommended aquarium size at 4 x tank turn over (3000l/hr) = 750lt
Inlet connection: 32mm ( 1" fitting)
Filter fleece: 10cm (4”) width – length 25m (82ft)

Dimensions
Base: 145 x 205mm
Top: 225 x 205mm
Height: 455mm

How do I install the ClariSea Roll Filter?

The Gen2 ClariSea is very flexible and easy to position within your sump:

You can hang it on the back, front, or sides of the most sumps.
You can free stand it on the base of a shallow sump with a water level below 200mm.
you can free stand it on a box or shelf in deeper sumps.
You can feed it from the front or from the back.
You can feed water from the top, side, or at an angle.
You can even pump feed it.

Motor button

Option to Manually advances fleece motor

Alarm button

Press alarm button for 1 - 2 seconds will turn off an audible alarm, but alarm condition will still be present

Red LED still flashing
Automatic advance of fleece disabled.
Motor button will still function as manual advance.

Pressing the alarm button for > 5 seconds:- Full reset - completely clearing alarm state
Disconnecting power: performs reset as above.

Normal Operation :

Initialization (Power on or reset)

Blue/Red LED both flashes 5 times (audible alarm will sound with each flash)
Blue LED will remain on.

Motor Advance

Manual or automatic, Blue LED flashes

Possible Alarm Conditions:

Possible roll jam/motor failure (float held in up position for more than 5 seconds)

Red alarm LED will flash
Audible alarm will sound for 2 seconds every 5 seconds
Automatic advance of fleece disabled.

Possible fleece empty (float not triggered within 8 hours)

Blue/Red LED both flashing, audible alarm will sound for 1 second every 2 seconds
Automatic advance of fleece disabled.

Possible installation error (float not triggered with 48 hours after initial set-up or reset)

Red LED will flash at 10-second intervals (audible alarm will sound with each flash)
Automatic advance of fleece disabled.

Important note: Only use the 20mm bolt to attach the motor to the Clarisea, do not use the 30mm bolt , this is for the clean fleece. Using the 30mm long bolt to attach the motor will result in damage to the motor assembly.

ClariSea SK-3000 Automatic Filter System G2 - D-D

Have a question?